Editing MG/Port Forwarding


= Port Forwarding =
Port Forwarding is a special configuration which you apply to your internet access device (typically a broadband router such as a cable or DSL modem/router) to be able to host Internet services on your own line. Many games require you to setup port forwarding if you would like to host games for other Internet players (you can still take part in games other people host without setting up port forwarding).



This page will attempt to provide you with hints on how to setup port forwarding on your own broadband router.
==Generic instructions==
To configure your router to work for hosting MegaGlest games,you first need to find out your internal (LAN) IP address. To do so, just run MegaGlest and navigate to the Custom Game menu (which is where you would end up when you wanted to host an Internet game). You may get to see an error message there saying that your router is not properly configured for Internet gaming. However, this page will also list your internal IP address (on the very top). Take note of it and exit MegaGlest.

Next, you need to setup ''port forwarding'' (AKA "internet services") on your broadband Internet access router, using the web interface it usually provides. Specifically, you need to forward the ''external port'' ''61357'' of type ''TCP'' to the ''internal port 61357'' on your computers' LAN IP address, that's the IP address you just noted down in the previous step.

See the next section for in-depth instructions on how to set this up easily on your specific router.
==portforward.com==
[http://portforward.com/ PortForward.com] has nice docs on how to setup port forwarding, including screen shots, for ''a lot'' of routers.
==Speedport w701V==
At first make sure that you are connected with your router, then open a browser and navigate to the ip of your router. As usal now you have to enter a pin to configure your router.

At first you have to have to activate port forwarding, in this example you can find it under "Networking" and there it's called "PPPoE Pass-Through".

Now you have to open the port 61357 for TCP, in this example you have to browse to "NAT & port rules", there you must click on "create new rule". The name of the rule does not matter. You have to enter a public port and a private client port, for both enter 61357.
<gallery type="slideshow" widths="399" position="center">
step2.png
step2.png
step3.png
step4.png
step5.png
step6.png
step8.png
step9.png
step10.png
</gallery>